RIPPER STRIPPER

DESCRIPTION & BENEFITS

RIPPER STRIPPER is a concentrated floor stripping solution with a solvent base which will quickly and effectively remove acrylic, polymer type floor sealers, wax and polish from vinyl, lino, rubber terrazzo, slate quarry and unglazed ceramic tile.

• Fast acting solution
• Contains no ammonia or caustics.
• Heavy scrubbing not required
• Contains a dye so that it can be seen on the floor during the stripping process.
• Free rinsing and has a pleasant sweet fragrance

Where to Use
Used to remove the old sealer finish without using a scrubbing machine, pads or brushes.

Directions
FLOOR STRIPPING –

Apply RIPPER STRIPPER diluted with up to 10 parts cold water, The dilution rate will vary dependant upon the amount of build up. Apply liberally with a mop and allow at least 10-15 minutes contact time.

Work systematically in areas no larger than 10sq metres. After contact time has elapsed, scrub with a machine using brush, brown or black stripping pad or a high productivity pad for heavily built up areas. Pick up slurry using a mop or a wet and dry vacuum cleaner. Rinse and allow to dry.

FLOOR SCRUBBING BACK – Apply RIPPER STRIPPER diluted with from 10 parts to 30 parts cold water and scrub back using a machine fitted with a brush or blue or green scrubbing pad. Apply solution liberally and scrub until the surface and embedded dirt is removed. Pick up slurry, rinse and allow to dry.

Usage Rate Approximately 10 Square Metres per Litre.

Warning
Avoid skin and eye contact and inhaling vapours.

First Aid
If poisoning occurs contact a doctor of Poisons Information Centre. PH 13 11 26. If swallowed do not induce vomiting, give a glass of water and seek medical attention. For inhalation, remove patient to fresh air, lay down and rest and seek urgent medical attention. If skin contact does occur remove contaminated clothing and wash thoroughly with water. For eye contact, irrigate with water for 15 minutes. If irritation persists seek medical advice.